It means that the enabled power management feature is optimizing the efficiency of the processor, either to save power or reduce heat within the system. This does not mean that the processor is operating at degraded performance levels. These types of power management features may result in very low tested frequency results. "Some power management features throttle or reduce the operating frequency of components within the system. There is one more thing that the guide states, see below The processor usage is 100% while running the Burn In Test, background processes can be killed and could make the system have that behavior. This why I believe that the scenario you are facing is normal but at the same time is considered expected. When running the test, I tried to minimize the window but it took a while, this was expected since all the processor resources were used in the test. And, the behavior was not exactly the same as the one you mentioned but it freeze for a couple of times while running the test and at the end of the test the result was passed. I ran test on a Surface Pro 4 which is a mobile platform. That is correct /thread/119601 TSMV, the Burn In Test enables all IPDT features and runs IPDT stress test for 120 minutes. at the very end of the test the monitor started to "flash" for about 20-30 seconds (like the program window was iconized and restored very quickly many times).Īs I said at the end I got a green "Pass" screen. the program entered in a non-responsive status for a few minutes, then continued to run. the program window disappeared for a few seconds (like it was iconized) then reappeared During the second hour the following events occurred a few times, randomly: So I started the Burn-In test, for at least the first hour I didn't notice anything. I use the integrated processor graphics, by the way. My Mother Board is Gigabyte GA-H97-D3H and I have 8 GB DDR3 RAM installed.
Additionally, it can be configured to enable (run) or disable (skip) individual default configurations are used for this mode of operation. The diagnostic can be configured to execute in one of two modes, presence test mode or verification mode. The diagnostic checks for brand identification, verifies the processor operating frequency, tests specific processor features and performs a stress test on the processor.
0 kommentar(er)
